The satin stitching on my Winged Whimsies samples is complete. The fabrics and colors came together well and the result is colorful and bright.
I'm not sure which panel is my favorite. The butterfly,
or the ladybug,
or maybe the dragonfly. I like how they each stand well on their own. Each bug was stitched with a zigzag stitch set between 3.5 or 4.0 for width and 0.75 for length. There are a few places where I used a 2.5 for smaller areas where the larger width would overtake the applique fabric.
I wanted to discuss a bit about my technique for making a satin stitched applique. Each applique piece is backed with fusible interfacing. Fusible interfacing is generally used in garment making. The fusible interfacing is a stabilizer for the tight zigzag stitching to keep the pieces lying flat. I also put a tear-away stabilizer on the backside of the applique panel to stabilize it as seen here.
I DO NOT use fusible web for this technique. Notice when looking at the completed dragonfly how the lower stitched layers DO NOT show to the top. Looking on the backside above, you can see the various stitching layers. If I had used fusible web, each layer of stitching would, in fact, show through.
One additional note about the tear-away stabilizer. I used Swedish tracing paper for this project. When done, notice that I made sure to tear most of the paper away (I didn't worry about the tiny pieces). If you block your projects as I do, either with steam or fully wetting, this tear-away can shrink and wrinkle your project.